Home / Applications
Applications

One material. Nine jobs.

The product is the whole building envelope. Start from the problem, not the SKU — the same EPS board does a different job in a cavity, under a slab and above a membrane. Filter by where it goes, or browse all nine.

Filter by zone
WallRoof

Insulated Roof, Wall & Ceiling Panels

A conventional roof needs a sheet, a separate insulation layer, a vapour strategy and a ceiling — four trades, four programme items, and a thermal envelope only as good a…

LiteSpan IBR & SS Roof PanelsLiteSpan Ceiling & Wall PanelsPolyCool & SuperCool
The full application →
Wall

Continuous Insulation (EIFS)

Heat leaks out of a building fastest at the places the insulation stops — the slab edge, the ring beam, the lintel, the steel stud. Continuous insulation (EIFS) answers t…

Bulk Insulation ProductsEIFS/ETICS External Wall InsulationLiteClad Steel Profiles
The full application →
Wall

Cavity Wall Insulation

A double-leaf masonry wall has an air cavity between the leaves that is doing very little thermal work, while mortar droppings bridge it and wall ties conduct through it.…

LiteCel Cavity & Drainage SystemPolykey Cavity InsulationBulk Insulation Products
The full application →
WallRoofFloor & ground

Cold Store & Refrigerated Buildings

A cold store is an envelope that has to hold a large, permanent temperature and vapour-pressure difference for 20+ years — the failure mode is not "poor comfort", it is c…

LiteSpan Ceiling & Wall PanelsLiteSpan IBR & SS Roof PanelsPanel Doors
The full application →
Floor & ground

Under-Slab & Slab-Edge Insulation

A ground-bearing concrete slab is thermally coupled to the earth and, at its perimeter, directly to outside air — so an uninsulated slab edge is usually the largest linea…

Bulk Insulation ProductsGeofoam Lightweight FillTechnoblock Slab Blocks & Void Formers
The full application →
Roof

Inverted (Protected-Membrane) Roof

A flat concrete roof must carry the waterproofing, the insulation, the SANS 10400-XA thermal requirement and usually paver or maintenance traffic in one build-up. In an i…

Bulk Insulation ProductsGeofoam Lightweight Fill2D Shapes & Sheets
The full application →
Roof

Warm Roof

A cold roof puts the insulation at ceiling level, where every rafter, purlin, downlight and service penetration short-circuits it, and where the deck itself sits on the c…

Bulk Insulation ProductsLiteClad Steel ProfilesLiteSpan IBR & SS Roof Panels
The full application →
Floor & ground

Geofoam Lightweight Civil Fill

Soft, compressible or low-bearing ground cannot carry the surcharge of a conventional soil or aggregate embankment without excessive settlement, lateral squeeze or bearin…

Geofoam Lightweight FillTechnoblock Slab Blocks & Void Formers2D Shapes & Sheets
The full application →
RoofWall

Agricultural & Poultry Housing

Poultry houses are thermally brutal: a large, low-mass roof plane over an environment that must hold a brooding set-point against night loss and a summer heat load, with …

LiteSpan IBR & SS Roof PanelsLiteSpan Ceiling & Wall PanelsPolyCool & SuperCool
The full application →
Not sure which applies?

Start from the compliance question

Check your roof or wall against its SANS 10400-XA target and we will tell you what closes the gap.

Open the XA compliance checker →

Technical resource

Who should we send this to?

We release technical documentation to named engineers and specifiers so we can support you properly on the project. One entry unlocks everything.

We will email you this document, and we may follow up about it. We will not add you to anything else unless you tick the box. We do not share or sell your details. How we handle your information.